Container deposit systems have benefits for municipalities, but MRFs are likely to see revenues decline as valuable PET and aluminum are removed from their material stream. | Myibean/Shutterstock
Though container deposit systems typically help lift recovery rates for covered materials, the programs also usually reduce tonnages of high-quality PET and aluminum going to sorting facilities. A new study helps to quantify those potential impacts.
The National Waste & Recycling Association (NWRA) released the study evaluating the effect of beverage container deposit systems on MRF costs and revenues, as well as the effects on municipalities.
Prepared by Resource Recycling Systems (RRS), the research modeled six deposit scenarios with variations based on beverage type and deposit value. Each scenario is based on an average-sized MRF with 93,600 tons per year throughput serving a community of approximately 1.25 million people in 473,000 households.
Overall, the findings were that container deposits lead to higher costs and lower revenues because high-value materials move to the deposit system and out of the MRF. The fixed cost per ton is higher as the cost to run the same equipment is spread across fewer tons, the report said.
The research estimates that municipalities could see an annual MRF cost increase of $2.50 to $5 per household.
Resa Dimino, RRS managing principal, said in a NWRA press release the study provided useful data and “shows a need for balance between system and policy.”
“We need to ensure that municipalities and MRFs are kept whole as higher quality materials are collected and removed from our waste streams and waterways,” Dimino said.
The scenarios included three different beverage combinations at a 5-cent deposit and a 10-cent deposit. The combinations were beer and carbonated soft drinks; beer, carbonated soft drinks and water; and all beverages, excluding milk.
The modeling assumed that aluminum, glass and PET beverage containers are included and that a 5-cent deposit yields a 65% redemption rate while a 10-cent deposit yields a 85% redemption rate.
Recycling rates increased in all scenarios, with the highest rates for an all-beverage deposit of 10 cents (77% for PET, 83% for glass and 89% for aluminum, up from a baseline of 29%, 25% and 50%, respectively).
Overall, more glass and aluminum than PET would leave the MRF system under all scenarios, and the study suggested that between 10,770 and 17,630 tons per year would no longer make its way to MRF sort lines. That would result in a revenue loss for a typical MRF of between $11.90 and $23.50 per ton marketed, depending on which deposit scenario was in place.
However, communities could see disposal cost savings from bottle bills, the study said, as well as a reduction in litter and marine debris and related cleanup costs. Higher-value materials are also more likely to be circular, it noted.
The report said further study is needed to understand the effect on recycling collection costs and throughput due to changes in the density of the recyclables mix.
To help offset the negative effects of bottle bills on MRFs, the study suggested policies like that in California, where MRFs are able to redeem containers in bulk and collect the deposits.
“Policy can be structured to capture the benefits of beverage container deposits – high recycling rates for target materials and materials more suited for closed loop applications – while ensuring that municipal recycling programs are not harmed,” the report said.
Bottle bill advocate weighs in
Susan Collins, president of the nonprofit Container Recycling Institute, said in a recent op-ed that the NWRA, by projecting an annual increase per household in MRF processing costs, is creating the impression that bottle bills will raise overall waste management costs for municipalities.
“Nothing could be further from the truth,” Collins wrote. She noted that several studies in the past 15 years have shown that municipalities typically see savings in the form of reduced collection costs, lower landfill tipping fees, less litter to remove from the environment and more.
She added that while the study also found that bottle bills remove high-value materials from MRF streams, “the impact of bottle bills on MRFs will be manageable.”
“The data show the total value of a MRF ton (as of August 2021) at $156, and the value at $154 under a full deposit system scenario (with all beverage containers on a 10-cent deposit). That $2 per ton drop (a 1.3% decrease) pales in comparison to the normal cyclical swings in commodity prices, as the study also shows,” Collins wrote.
More stories about container deposits
- California CRV rulemaking touches on labels, PCR
- Ending legislative sessions advance plastics bills
- California grants increase deposit return system options
